GRT Avionics

I have an early Safe-fly and echo package this is a Rev-A red labeled unit connected to a Sport EX connected as GPS 1 and a G400w connected as GpS 2, The issue I am having is the Safe-Fly GPS it taking a several minutes to come up on screen. The Rev-B documents show GPS backup power is not used on ...

Works perfectly
Thanks

Hi all
I would like to connect a Air Fuel O2 Sensor to an analog input.
The sensor outputs 0v-5v for 10-20 a/f.
any suggestions as to where to begin programming?
thanks

I am setting up a SDSefi system to interface with an EIS 2000, the SDS outputs 25000 pulses per gallon,
I would like to calculate a good starting point for the FF calibration.
any ideas on the formula for fuel flow?
Thanks
Rob Henderson
Glastar N24TU

Ok thats what I was thinking, how do I calibrate the sensors without running the engine?

has anyone else checked the fuel quantity before engine start and after?
I see a 2 gallon reduction in fuel quantity with the engine running for both tanks.
it seems to be voltage related, if I shut the alternator off the system voltage reduces and the fuel quantity goes back up.
the resistive ...

My hxr reads .5v low on all 3 inputs as measured by my fluke meter at the same points.

Anyone have the coupon code for the chart data discount?

I have an HXr and I am trying to get an ft-1827-2 to work to measure gear box temp on the discreet analog input 6. I am using the HXr internal resistor and have tried all of the Eis calibration settings. Any suggestions?

my wife has threatened to rerecord the messages to ad "dumbass" to the end of each message, of course in her voice.