Page 1 of 1

Fuel flow programming with a SDSEfi system

Posted: Thu Jun 01, 2017 9:01 pm
by Rob Henderson
I am setting up a SDSefi system to interface with an EIS 2000, the SDS outputs 25000 pulses per gallon,
I would like to calculate a good starting point for the FF calibration.
any ideas on the formula for fuel flow?
Thanks
Rob Henderson
Glastar N24TU

Re: Fuel flow programming with a SDSEfi system

Posted: Sat Jun 03, 2017 9:29 pm
by JimB
Rob,

When GRT used Floscan senders, model 201B, the starting Flo Cal setting was 200. That transducer outputs about 32000 pulses per Gallon at 16 gph.

From this just make it proportional, maybe about 150.

Jim Butcher