Display
Posted: Wed Oct 30, 2013 1:40 pm
I've noticed that when I select "Set Limits" (pushing the left and center button simultaneously), the display goes into a reverse mode. In other words, the characters become a light character on a dark background. I think EIS stays in this mode until powered off and back on again.
The display is difficult to read in sunlight when in this reversed mode. And I go to Set Limits during flight quite often since I have a auxilliary fuel tank that I pump into my main fuel tank while in the air and I update the amount of fuel on board at that time.
Is there a way to get back to the normal display mode other than powering off EIS?
Thanks
Jim Butcher
The display is difficult to read in sunlight when in this reversed mode. And I go to Set Limits during flight quite often since I have a auxilliary fuel tank that I pump into my main fuel tank while in the air and I update the amount of fuel on board at that time.
Is there a way to get back to the normal display mode other than powering off EIS?
Thanks
Jim Butcher