DA and Missed Altitude buttons - Synthetic Aproaches
Posted: Fri Mar 15, 2024 4:21 pm
Yesterday, I was working on flying SAPs to my grass field - no Terpsed approaches for it, so I've loaded the runway info with user-data base file. No problems - the AP captures the extended runway line and flies me down the 3deg slope, and the Flight Director chevrons allow me to do it manually. Excellent!!
However, though the Decision Altitude and the Missed Alt buttons appear on the bottom, only the first time they appeared was I allowed to enter the altitude data for each. After that, when re flying the SAP, the buttons for each would show, but when pressed to change the values, Id get bounced to another page that had "Clear" and I think "Exit" buttons and but couldnt re enter the altitudes - ie it wasnt activating the buttons like the first time so I could use the right knob to change them. After hitting Clear, the numbers above each disappeared and became dashed lines instead. But again I couldnt get it to let me enter new numbers for those......
As mentioned, this was yesterday so Ive only worked with the SAPs once, though I flew about a dozen SAP approaches to the same field to work through the procedures.
What am I doing wrong wrt the DA and Missed Alt Buttons (so I can re-enter/edit the alts at will)?
Thanks for any help.
However, though the Decision Altitude and the Missed Alt buttons appear on the bottom, only the first time they appeared was I allowed to enter the altitude data for each. After that, when re flying the SAP, the buttons for each would show, but when pressed to change the values, Id get bounced to another page that had "Clear" and I think "Exit" buttons and but couldnt re enter the altitudes - ie it wasnt activating the buttons like the first time so I could use the right knob to change them. After hitting Clear, the numbers above each disappeared and became dashed lines instead. But again I couldnt get it to let me enter new numbers for those......
As mentioned, this was yesterday so Ive only worked with the SAPs once, though I flew about a dozen SAP approaches to the same field to work through the procedures.
What am I doing wrong wrt the DA and Missed Alt Buttons (so I can re-enter/edit the alts at will)?
Thanks for any help.