Search found 676 matches
- Tue May 11, 2021 4:40 am
- Forum: EIS Programming
- Topic: EIS 4000 /10-180 ohm fuel sender compatability
- Replies: 3
- Views: 6430
Any sender with a linear output in the 0-5V range will work. The EIS aux inputs are 5V max. A voltage divider could be used if the voltage is higher.
The procedures need to be updated in the Garmin 175. The Garmin 175 loads the approach, follows the procedures, then computes the deviations and sends the deviation data to the HXr. The HXr displays and follows the deviations and some basic waypoints but it doesn't know anything else about the appro...
- Thu May 06, 2021 1:36 am
- Forum: Android App
- Topic: GRT Remote app for Android now available!
- Replies: 7
- Views: 10655
Only a few work and it's usually impossible to tell if one will work just by looking at the product. The one we know works is the IOGear GBU521.
- Wed Apr 28, 2021 12:34 am
- Forum: ADS-B/Weather/Traffic
- Topic: uAvionix EchoUAT/SkyFyx (generic) interface to GRT HX?
- Replies: 2
- Views: 108
The only official way to change anonymous mode is through the echo app so there's no disadvantage for that. Your ADS-B In wiring sounds correct. Configure the EFIS input for 115200 and ADS-B. The EFIS can't send anything directly to the echoUAT except altitude. The echo still needs to get squawk by ...
- Fri Apr 16, 2021 4:16 am
- Forum: Product Feature Requests
- Topic: Flight plan format
- Replies: 5
- Views: 1439
No. It looks like trk/trkseg is a generic way to record past positions. It's very close though. If you change trk to rte, remove the trkseg tags, change trkpt to rtept, and remove the type/purpose from the name tags (the name should be just the identifier, "LSGY" not "LSGY,Airport&quo...
- Mon Apr 12, 2021 10:34 pm
- Forum: Sport EX/Horizon EX
- Topic: Horizon EX sends NAV frequencies to SL30, but won't send COM freqs.
- Replies: 1
- Views: 109
"COM1 Device" can't be set to 430W-1 because the EFIS can't control the frequencies of a 430W. This should be set to "None" so the EFIS knows it can't control COM1. With the serial port input and output set to 9600 SL30-2 and the COM2 Device set to SL30-2, sending frequencies sho...