I am setting up a SDSefi system to interface with an EIS 2000, the SDS outputs 25000 pulses per gallon,
I would like to calculate a good starting point for the FF calibration.
any ideas on the formula for fuel flow?
Thanks
Rob Henderson
Glastar N24TU
Fuel flow programming with a SDSEfi system
-
- Posts: 32
- Joined: Mon Mar 11, 2013 7:31 pm
Re: Fuel flow programming with a SDSEfi system
Rob,
When GRT used Floscan senders, model 201B, the starting Flo Cal setting was 200. That transducer outputs about 32000 pulses per Gallon at 16 gph.
From this just make it proportional, maybe about 150.
Jim Butcher
When GRT used Floscan senders, model 201B, the starting Flo Cal setting was 200. That transducer outputs about 32000 pulses per Gallon at 16 gph.
From this just make it proportional, maybe about 150.
Jim Butcher