GRT Avionics

I have a NavWorx ADS-B and a dual display Hx system. The NavWorx RS232 Display Serial Data Input (Pin 24), and, the RS232 Display Serial Data Output (Pin 5) are connected to display unit #1 Serial 7 In and Serial 7 Out. When I am in the General Setup for Display Unit #1, what baud rate and value should I use when configuring Serial 7 in & out?

Thanks..

I believe the answer is 115200 baud rate

For the NavWorx ADS600-B

Serial Port 7 Rate: 115200
Serial Port 7 Input: ADS-B
Serial Port 7 Output: ADS600-B

The baud rate is also configured in the NavWorx unit and must match.

The "ADS600-B" output was added in HX software version 5c.

thanks

Jeff: My Navworx is fed altitude from an HX serial port and the 327 transponder controls the squawk etc. What does selecting ADS600B on the EFIS to Navworx serial out do? I have always had the wire in place, but always in the off selection.

Thanks

If your NavWorx unit is linked to another transponder, the only benefit of the output is the ability to change the call sign without connecting a computer to the maintenance port.

Thanks Jeff