Installing multiple Current Sensors (Hall effect)
Posted: Sun Nov 27, 2022 9:38 pm
Good Day All,
Installing my remote GRT EIS and have a couple of questions:
1. Installation of the "Current Sensor" is nowhere to be found in the Remote EIS Documentation? Can someone advise where else it is listed? The P/N: CS-01 came with my EIS but I cannot find the information on how to install and to which pins on the EIS, etc...
2. I have another Backup Alternator that uses Hall effect sensors on my primary Alternator and displays to a separate (non-EFIS) panel mounted instrument. My question is can I put these next to each other or will this cause some type of interference?
Thanks,
Gary E
VELOCITY XLRG
ARB
Installing my remote GRT EIS and have a couple of questions:
1. Installation of the "Current Sensor" is nowhere to be found in the Remote EIS Documentation? Can someone advise where else it is listed? The P/N: CS-01 came with my EIS but I cannot find the information on how to install and to which pins on the EIS, etc...
2. I have another Backup Alternator that uses Hall effect sensors on my primary Alternator and displays to a separate (non-EFIS) panel mounted instrument. My question is can I put these next to each other or will this cause some type of interference?
Thanks,
Gary E
VELOCITY XLRG
ARB